Bondtech CHT® Coated Brass Nozzle, 1.0 mm

Replacement Shaft assembly for our Bondtech Mini Geared (BMG), SingleDirect and DualDirect extruders. It includes the set screw for primary 1.75/5.0 drive gear.Note: New improved revision from Bondtech, where the gear wheel is in white now! For more information see link

StealthBurner RGB LED Kit, pre-wired. Total of three SK6812 RGBNW LEDs. Wire terminated with 3-pin Molex Microfit 3.0 connector. Hint Use our prepared connection cable StealthBurner RGB LED Wire Harness to update your wire harness. Note The M42 hexnut and 3D printed parts are not part of this kit and are pictured for demonstration purposes only.

They are manufactured by Bondtech in-house, and will fit the following hotends/blocks: Mosquito® / Magnum Mosquito® Liquid Mosquito® Magnum+ Copperhead™ E3D Chimera and Kraken E3D V4, V5 and V6 blocks Prusa i3, Prusa Mini RepRap M6 Features 1 unit per pack; Available sizes : 0.40, 0.50, 0.60, 0.80, 1.0, 1.4 and 1.8mm; Optimized for 1.75mm filament; Compatible with 2.85mm filament. Requires 6mm wrench Main Bondtech CHT® Advantages Higher melt capacity by increasing the surface area of the heating walls Affordable price Machined with ultra-precision Brass nozzle with Nickel coated surface Follows nozzle standards: RepRap (M6×1×7.5×12.5) MK8 (M6×1×5×13) May be used with 1.75 or 2.85mm hotends. Advantages of the Bondtech CHT® technology: Bondtech CHT® nozzles split the filament into 3 thinner strands allowing to melt the material from within. In doing so, the material melts faster and higher flow rates can be used. Core Heating is a patented technology Registration number: EP3445568A1Nozzles for 3D printers made of metal with at least one or a multitude of holes to increase the surface area of the heating walls. Advantages of the Nickel Coating A Nickel coating is applied to our Coated Brass nozzles to provide protection against corrosion, erosion, and abrasion. Nickel coated nozzles have more corrosion resistance and lower coefficient of friction, which allows slicker feeding of material and delays plastic adhesion to the nozzle's surface.

Endstop Microswitch usable for X/Y/Z. Type: D2F-5LRating: 250 V/AC - 5A

Thumbscrew replacement for Bondtech extruder.

Bondtech drive gear kit in hardened and surface protected steel. Precision cnc-machined. Super sharp teeths for maximum grip on the filament. The perfect choice for a high-performance feeding system. Extremely high wear resistance for use with abrasive filaments. These drivegear kits come as a set consisting of a primary drive gear, a secondary drive gear, bearings and a shaft. Gear set for filament size 1.75 mm, primary gear with inner diameter 5 mm, secondary gear with two needle bearings, M3x2 setscrew and one 3x20 mm shaft. Gear set for filament size 1.75 mm, primary gear with inner diameter 8 mm, secondary gear with integrated needle bearings, M4x3 setscrew and one 4x22 mm shaft. Gear set for filament size 2.85 – 3.0 mm, primary gear with inner diameter 8 mm, secondary gear with integrated needle bearings, M4x3 setscrew and one 4x22 mm shaft. A Lithium based grease is recommended to use on the gear section and inside the needle bearings for low friction and to avoid wear. A small dab of grease is enough.