Picture similar to product
Content: 1 piece
Out of stock
Product number: BTE-DG-175-5
Product information "Bondtech Drive Gear Set, 1.75 mm Filament, 5 mm Shaft"
Bondtech drive gear kit in hardened and surface protected steel. Precision cnc-machined. Super sharp teeths for maximum grip on the filament. The perfect choice for a high-performance feeding system. Extremely high wear resistance for use with abrasive filaments.
These drivegear kits come as a set consisting of a primary drive gear, a secondary drive gear, bearings and a shaft.
- Gear set for filament size 1.75 mm, primary gear with inner diameter 5 mm, secondary gear with two needle bearings, M3x2 setscrew and one 3x20 mm shaft.
- Gear set for filament size 1.75 mm, primary gear with inner diameter 8 mm, secondary gear with integrated needle bearings, M4x3 setscrew and one 4x22 mm shaft.
- Gear set for filament size 2.85 – 3.0 mm, primary gear with inner diameter 8 mm, secondary gear with integrated needle bearings, M4x3 setscrew and one 4x22 mm shaft.
A Lithium based grease is recommended to use on the gear section and inside the needle bearings for low friction and to avoid wear. A small dab of grease is enough.
Properties "Bondtech Drive Gear Set, 1.75 mm Filament, 5 mm Shaft"
|Voron / Extruder:||Afterburner, Jetpack, M4, Pocketwatch 2|
Bill of Materials for "Bondtech Drive Gear Set, 1.75 mm Filament, 5 mm Shaft"
Our Bill Of Materials is a usefull tool while sourcing your VORON.
|Model / Spec||120||180||230||250||300||350|
0 of 0 reviews
Bondtech Shaft Assembly
Replacement Shaft assembly for our Bondtech Mini Geared (BMG), SingleDirect and DualDirect extruders. It includes the set screw for primary 1.75/5.0 drive gear.Note: New improved revision from Bondtech, where the gear wheel is in white now! For more information see link
MR85 2RS / MR 085 2RT, 5 x 8 x 2.5 mm, Miniature Deep Groove Ball Bearing
Miniature ball bearings are deep groove ball bearings in small. Their dimensions make them suitable for special applications. In addition, they allow very high speeds with low noise.
Variants from €0.99*
StealthBurner RGB LED Kit
StealthBurner RGB LED Kit, pre-wired. Total of three SK6812 RGBNW LEDs. Wire terminated with 3-pin Molex Microfit 3.0 connector. Hint Use our prepared connection cable StealthBurner RGB LED Wire Harness to update your wire harness. Note The M42 hexnut and 3D printed parts are not part of this kit and are pictured for demonstration purposes only.
> 500 available
OMRON D2F-5L Microswitch
Endstop Microswitch usable for X/Y/Z. Type: D2F-5LRating: 250 V/AC - 5A
Brass Heat Insert, 5 x 4 mm, M3
Brass heat inserts, specially developed for FDM 3D printed parts and post-insertion.
Content: 100 piece (€0.09* / 1 piece)