Prices incl. VAT plus shipping costs
Ships in approx. 3 Workdays
- Order number: LDO-42STH48-2004AC
- Supplier: LDO
- Width: 6 cm
- Height: 4 cm
- Length: 3 cm
- Weight: 0.05 kg
Suitable for VORON2 V2.4 Z axis.
NEW: shaft length increased by 2 mm to match BOM spec of 24 mm.
|WEEE-reg. no.:||DE 68334994|
|Build:||250x250x230mm, 300x300x280mm, 350x350x330mm|
|Step Angle:||1.8° +/- 5%|
|Holding Torque:||59 Ncm|
|Rated Current:||DC 2.0A / Phase|
|Inductance:||3.0 x (1 +/- 20%) mH / Phase|
|Rotor Inertia:||85 g. cm²|
|Resistance (@ 20°C):||1.6 x (1 +/- 20%) ohm / phase|
|Insulation Class:||Class B 130°C|
|Insulation Resistance:||>= 100 Mohm (DC 500V)|
The stepper quality is perfect, my printer runs perfectly with it. It's a little bit more noisy than I expected, but of course this is subjective matter it's nothing to worry about is not that bad stepper at all, it's one of the best you can get.
Up to now just building experience. Stepper looks like good quality. Building without any issue. I like the connector attached to the motor. This helps, that long wires don't dangle around during build and will avoid a lot of rewiring work in case a stepper needs to be replaced.