GraviFlex® Magnetic Sheet 200. One side prepared with self-adhesive tape. We sell it a little oversized to allow for alignment errors when applying. Just cut off the excessive material with a utility knife. Can even withstand temperatures of up to 200°C for a short time. It is permanently designed for operating temperatures of 120°C.
|Remanence Br:||243–263 mT|
|Coercive Field Strength HcB:||179–203 kA/m|
|Coercive Field Strength HcJ:||211–257 kA/m|
|Energy product (B×H)max:||11,1–13,5 kJ/m³|
|Adherence:||ca. 130 g/cm²|
Good quality, works well.
External packaging suffered abuse but mag plate survived in good condition. Oversize is very appreciated when mounting it to the build plate. Shipping process required patience, especially USPS.
Very good and strong adhesion
Recommended. Oversize is a very nice touch to cut it up exactly as needed. Adhesive is strong and works very well.
Using thick (1mm) PEI on a double-sided energetic flex-plate I could only use one side as the plate warped.
Using this, I can finally print on both sides (though only barely, I need to bend it completely straight for it to work and would probably not work with a really large warp-prone print.
Still solid upgrade. This magnet is loads better than the energetic crap. And the larger size makes application a breeze.
Much stronger than Energtic 3Ds
Very strong magnet, nicely over-sized to allow trimming. A highly recommended upgrade from the one that you get with the Energtic flex plates at this size should definitely help with the larger prints pulling the steel from the bed at the edges.