Filter
–
OMRON TL-Q5MC2-2M Inductive Probe
Genuine OMRON TL-Q5MC2 2M NPN NC inductive sensor, suitable as Z probe, with a 5mm sensing distance. Note:* does not sense alumium early enough. Requires a springsteel sheet. needs longer screws than the BOM sensor (2x M3x25 instead of M3x20)
€49.99*
Top
DIY Z Endstop PCB, requires custom printed part and soldering. Contents 1x PCB 1x 3-Pin JST-XH connector 1x Omron D2F-5L Hint Use our prepared connection cable Nozzle Endstop Wire Harness Downloads Z-Switch_FermioLabs_Rev1.stl Note: The pins of the connector and microswitch have to be cutted very flat before soldering!
€4.99*
Top
Voron Nozzle Endstop Wire Harness
Wire harness for our Nozzle Endstop with 100cm of black Helukabel Heluflon®-fep-6y 0.25mm² and on both ends you have a already crimped 3-pin JST-XH connector.
€4.99*
Tip
Top
V24
TRI
X/Y Hall Effect Endstop for contactless end position triggering. The Endstop is plug&play for our Wire Harness! Contents 1x Hall Effect Endstop, ready and 100% tested 2x 6x3mm black magnets Note: For using it, you need a different print part from the release ([a]_endstop_pod_hall_effect.stl)
€14.99*
Top
V24
TRI
Voron X/Y Microswitch Endstop
DIY X/Y Microswitch Endstop PCB. This PCB is compatible with our Wire Harness! Soldering and printed part required. Contents 1x PCB 1x 4-Pin black JST-XH compatible connector Note: you need two Omron D2F-5L or similar microswitches! Download Microswitch_Edge_Pod.stl
€2.99*