Round Neodym Magnets, 6 x 3 mm, N35H (high temp), electrically conductive

Endstop Microswitch usable for X/Y/Z. Type: D2F-5LRating: 250 V/AC - 5A

Round neodym magnet, 6 x 3 mm, N52 (≤ 80 °C), epoxy coated black. Note Electrically non conductive.

Brass heat inserts, specially developed for FDM 3D printed parts and post-insertion.

Optical sensor PCB for TAP including adapter cable to our wire harness for Plug&Play, but you need to ensure 5V supply for this board. The design includes a supply polarity protection. INFO: New version! Warning Do not connect or disconnect the PCB when the printer is powered! Technical Data 5V supply voltage only Open drain signal output Optional 10k pull-up (against +5V) on signal output (via solder bridge) OPB973N51 sensor (signal level is inverted!) Contents 1x full assembled and 100% tested PCB 1x short cable (JST-PH => Molex Microfit 3.0)

StealthBurner RGB LED Kit, pre-wired. Total of three SK6812 RGBNW LEDs. Wire terminated with 3-pin Molex Microfit 3.0 connector. Hint Use our prepared connection cable StealthBurner RGB LED Wire Harness to update your wire harness. Note The M42 hexnut and 3D printed parts are not part of this kit and are pictured for demonstration purposes only.

Fermio Labs miniature linear guideway; single rail cut to length with a single long block. Highest preload (Z1) and normal (N) precision guarantees a stiff / play-free and binding-free motion. Unlike most of the linear guideways produced in China, our blocks feature a functional injection hole / grease port for lubrication which is compatible with our lubrication kit. Warranty The blocks and rails are non-interchangeable - keep the blocks on the rails! A violation does expire warranty effectively. Cleaning We strongly recommend to clean the rails before lubrication. Put a zip tie through the very last holes to ensure the block can not escape the rail. Fill a glass with some grease solvent and soak the blocks for at least an hour. Rinse the blocks and wipe the rail from any residue grease with a lint-free cloth. Lubrication We recommend to lubricate the ball races and bearing balls with grease, and cover the entire rail itself in a thin coat of grease to prevent oxidation. Recommended lubricants (in no particular order): CPC Lubrication Kit 18G Fuchs Planto Multispray S Fuchs Lagermeister BF2 Mobilux EP 1 or EP 2 HIWIN G05 Note: lubricants containing MoS2 or graphite must not be used.